1. The height of the shower mixing valve from the ground
When we install the shower, the first thing we must determine is the height of the shower mixing valve from the ground. Before installing the shower, we have already determined the location of the shower. Generally, it is controlled within a height range of about 90~100cm. In this range, we can also make fine adjustments according to our own height. But generally do not exceed 110cm, if it is too high, it may cause the shower riser to be unable to install.
2. Reserved height of shower faucet
The reserved wire head of the installed shower faucet is just buried in the wall tiles. It is best to just cover it with a decorative cover. Otherwise it will look unsightly. Therefore, it is best for everyone to consider the place when laying the pipeline. Generally, it is 15mm higher than the rough wall, so that the wire head can be buried when the tile is finished to ensure the beautiful wall.
3. The space reserved for the inner wire elbow of the shower head
The general standard for the reserved spacing of the inner wire elbow of the shower is about 10~15cm. Generally, when buying a shower, the seller will give two adapters, so that the water inlet of the mixing valve can be well connected to the hot and cold water outlet on the wall. However, as far as possible, do not use the adapter to transfer, so it is more beautiful.
1. After the faucet is installed, it must be level and not inclined, about 900-1100mm away from the ground. Be careful not to damage the plating surface when installing the faucet with a wrench.

2. The shower head is installed in the installation hole and the expansion pipe is respectively driven into it, and the wall base is fixed to the wall with self-tapping screws. Note: The wall base must be on the same center line as the faucet outlet joint.